16
Software / Re:Raspberry PI2/Openelec 6.0/MediaPro III : Freeze or "no data" after some hours
« am: Januar 06, 2016, 10:35:19 Nachmittag »
Bravo ! Good diagnostic !
This evening I've power on my Raspberry and my HUB. But VDR proclaims "no data" because my HUB's power supply is dead
I've plugged the tuner directly on the Raspberry and it's WORKING !!
For change the "scaling_governor" the solution is :
This is my "autostart.sh"
Two references :
* http://openelec.tv/forum/148-usage/77654-setting-cpu-scaling-governor-to-performance
* http://wiki.openelec.tv/index.php?title=Autostart.sh
About of your demands
But, don't be too optimistic, few minutes it's not enough to validate the solution. I'm going to schedule a record and see tomorrow if I can see a channel.
If this is the solution, the next step is to have the remote control usable
This evening I've power on my Raspberry and my HUB. But VDR proclaims "no data" because my HUB's power supply is dead
I've plugged the tuner directly on the Raspberry and it's WORKING !!
For change the "scaling_governor" the solution is :
Code: [Auswählen]
cd /storage/.config
touch autostart.sh
chmod a+x autostart.sh
vi autostart.sh
This is my "autostart.sh"
Code: [Auswählen]
(
for gov in /sys/devices/system/cpu/cpu[0-9]*/cpufreq/scaling_governor
do echo "performance" > $gov
done
) &
Two references :
* http://openelec.tv/forum/148-usage/77654-setting-cpu-scaling-governor-to-performance
* http://wiki.openelec.tv/index.php?title=Autostart.sh
About of your demands
Zitat
First of all try to connect the tuner directly not via the USB hub.All paper that I've read said to use a HUB to connect the tuner... Maybe for the previous version of the Raspberry Pi2
But, don't be too optimistic, few minutes it's not enough to validate the solution. I'm going to schedule a record and see tomorrow if I can see a channel.
If this is the solution, the next step is to have the remote control usable