Sundtek Support Forum

Hi,

you can contact us about that topic on Friday (1. February 2019). Basically we support docker systems - but still need to update some installer scripts.

Hi,

What is the best way to contact you ?

Did you also install the driver inside the docker environment?

No did not, the other adapter TBS6902 is reconized with only the driver instald on the host/unraid.

Driver installed correctly and dongle works but after a reboot I have to run the setup again.

adding /opt/bin to environment paths
unpacking...
checking system... ARM SYSV HF System detected
installing (netinstall mode) ...
Downloading architecture specific driver ... armsysvhf
Download finished, installing now ...
installing remote control support
finalizing configuration... (can take a few seconds)
installing libmediaclient interception library
Starting driver...
This system is using systemctl for starting the driver...
done.

Thank you for the awnser, i switcht to a rasberry pi

This case can be closed

I’m trying to install the sundtek driver on my router, its a Netgear R6250  with dd-wrt Firmware: DD-WRT v24-sp2 (08/07/14) kongac

There is a 32gb stick mounted on /jffs and there is 211.4 MB free of system memory.

But when run ./sundtek_netinst.sh I get the following error :
unpacking...
checking system... Your system is currently unsupported
also check that this installer is not corrupted due a bad download
/tmp must not be mounted with noexec flag, otherwise the installer
won't work

In case you do not have enough free space on your system you might
use the network installer
http://sundtek.de/media/sundtek_netinst.sh

in case your system is really unsupported please contact
our support via mail <kontakt@sundtek.de>

removing driver.....
driver removed...

I did a ./sundtek_netinst.sh –u
Then go to the control center and start the driver

But I get e error :

Hi ,
I am not able to skype , can i provide some other information ?

after a reboot :


root@et8000:~#  cat /proc/bus/nim_sockets
NIM Socket 0:
        Type: DVB-C
        Name: TDA10024
        Has_Outputs: yes /opt/bin/mediaclient --mount=192.168.1.200

        Frontend_Device: 0
        I2C_Device: 3


Then i run /opt/bin/mediaclient --mount=192.168.1.200 with output :
driver is possibly not started, trying to start now...
Successfully mounted: 192.168.1.200

then  cat /proc/bus/nim_sockets gives the following output :
NIM Socket 0:
        Type: DVB-C
        Name: TDA10024
        Has_Outputs: yes
        Frontend_Device: 0
        I2C_Device: 3
NIM Socket 1:
        Type: DVB-C
        Name: Sundtek DVB-C (192.168.1.200) (USB)
        Has_Outputs: no
        Frontend_Device: 1
        I2C_Device: -1
NIM Socket 2:
        Type: DVB-C
        Name: Sundtek DVB-C (192.168.1.200) (USB)
        Has_Outputs: no
        Frontend_Device: 2
        I2C_Device: -1