English > Sundtek MediaTV Pro (Europe)
Sundtek DVB-C tuner with Octagon SF8008 - Openvix latest image
manifesto1969:
Hi,
I have just purchased the Octagon SF8008 which has the latest OpenVix image installed
I downloaded the Sundtek Control Centre and downloaded the latest drivers
However, in the tuner does not show in the Setup->Tuners->Configure section of OpenVix
This shows up on a VU+ Solo2 with latest OpenVix image without issue.
I'm no expert on this and wondered if it is a driver issue and if so whether new drivers for the Octagon SF8008 will be released?
Your help is appreciated
manifesto1969:
--- Zitat von: manifesto1969 am Januar 17, 2019, 05:06:35 Nachmittag ---Hi,
I have just purchased the Octagon SF8008 which has the latest OpenVix image installed
I downloaded the Sundtek Control Centre and downloaded the latest drivers
I have the tuner to autostart in the Control Centre
I've reboot the receiver.
However, in the tuner does not show in the Setup->Tuners->Configure section of OpenVix
This shows up on a VU+ Solo2 with latest OpenVix image without issue.
I'm no expert on this and wondered if it is a driver issue and if so whether new drivers for the Octagon SF8008 will be released?
Your help is appreciated
--- Ende Zitat ---
Sundtek:
Hi,
can you join the chat tomorrow and check with our support? Today is already allocated for other customers.
https://support.sundtek.de/chat.php
manifesto1969:
--- Zitat von: Sundtek am Januar 17, 2019, 05:49:24 Nachmittag ---Hi,
can you join the chat tomorrow and check with our support? Today is already allocated for other customers.
https://support.sundtek.de/chat.php
--- Ende Zitat ---
Sure, is there any particular time I need to be on the chat channel?
Sundtek:
I would say 10am? But you can advice another time too.
Navigation
[0] Themen-Index
[#] Nächste Seite
Zur normalen Ansicht wechseln