Sundtek Support Forum

English => Sundtek MediaTV Pro (Europe) => Drivers => Thema gestartet von: jteeuw am September 28, 2015, 04:17:50 Nachmittag

Titel: Driver for Netgear R6250 with Tomato Firmware
Beitrag von: jteeuw am September 28, 2015, 04:17:50 Nachmittag

Hi i trying to install the driver on a Netgear R6250 with Tomato Firmware 1.28.0000 -131 K26ARM USB VPN-64K firmware but get the following error :

unpacking...
checking system... OpenWRT/Fritzbox support enabled
using new ARM4 SYSV uClibc toolchain
installing (netinstall mode) ...
Downloading architecture specific driver ... arm4uclibc
Download finished, installing now ...
Trying to use /tmp/opt/bin for driver installation
please note this installation will only be temporary
since we don't have write access to /opt/bin
Starting driver...
./mediasrv: can't load library 'librt.so.0'
./mediaclient: can't load library 'librt.so.0'
./mediaclient: can't load library 'librt.so.0'

Titel: Re:Driver for Netgear R6250 with Tomato Firmware
Beitrag von: Sundtek am September 29, 2015, 02:06:28 Nachmittag

Hi,

it doesn't look so bad you need to install librt

I think it's opkg install librt ?

Titel: Re:Driver for Netgear R6250 with Tomato Firmware
Beitrag von: jteeuw am September 30, 2015, 01:32:41 Nachmittag

Thank you for the awnser, i switcht to a rasberry pi

This case can be closed