Sundtek Support Forum

English => {Single, Dual, Quad} Sundtek SkyTV Ultimate => Thema gestartet von: sbi am November 11, 2013, 11:24:24 Nachmittag

Titel: Help with monobloc LNB (Hotbird/Astra)
Beitrag von: sbi am November 11, 2013, 11:24:24 Nachmittag

Hello,

I'm have difficulties tuning to Astra 19.2 with the SkyTV Ultimate USB.

This works fine (13.0E):

~$ mediaclient -d /dev/dvb/adapter1/frontend0 -m DVBS -f 11137000 -S 27500000 -V H -E 3/4 -M QPSK
Using device: /dev/dvb/adapter1/frontend0
Setting DVB-S/S2 tune Parameters
using HI/LO Band frequency: 11137000
Modulation: QPSK (DVB-S)
Symbolrate: 27500000
Voltage: 18 Volt (Horizontal)
FEC: 3/4
Tone OFF
Frequency: 1387000
Syntax OK
Checking for lock:
. [LOCKED]

How can I switch to 19.2E?
I have tried --secmini=A/B but it seems to have no effect.
mediaclient --list-diseqc gives mediaclient: unrecognized option '--list-diseqc'

mediaclient --build and mediasrv --build both give
Build date: 2013-11-06 14:42:40

Can you help?

-Stéphane

Titel: Re:Help with monobloc LNB (Hotbird/Astra)
Beitrag von: Sundtek am November 12, 2013, 12:03:26 Vormittag

Well it depends on your switch. Does it support modulated burst tone / Sec Mini?

Zitat

/opt/bin/mediaclient --secmini=A -d /dev/dvb/adapter0/frontend0

I think you might need to take care about the standby feature which kicks in after 15 seconds it might reset the previous settings on the LNB.


you can send manual Diseqc commands

Zitat

/opt/bin/mediaclient --diseqc="AA BB CC DD" -d /dev/dvb/adapter0/frontend0

where AA BB CC DD is the Diseqc Command in HEX