English > Sundtek MediaTV Pro (Europe)

Remote receiver

(1/2) > >>

RLM:
Where on the device is the receiver located? If I plug this device into a USB port on the back of my media-center, will it be able to receive signal from the remote without "line-of-sight"?

Sundtek:
We will check for the technical specification of this. We are aware that the remote control is not the best unit so we are thinking about a better and bigger one. The receiver is located behind the transparent dark plastic.

It might be possible that the remote control is not strong enough for this, we are working on providing support for alternative remote controls soon.

gergomez:
I have also problems with the remote, I'm not able to make it working, it seems that it is not sending any signal. I first tried with the battery in a correct position, but it does not work, then I change the battery orientation and try again with no success, then I found the + symbol in the side, so put back the battery in the correct orientation, but no luck either. I have configure the lirc daemon as indicated, but nothing is being sent from the lirc socket. I have check with irw and get nothing. Any way I can check if the remote is broken?

Sundtek:
There's an easy check if the battery is still alive, point your remote control into the webcam and check if it is blinking. When inserting the remote control the wrong way the battery will be over very soon!

For setting up the remote control you might also try

/opt/doc/lirc_install.sh

The installation manual was written for ubuntu 9.04, the setup might have changed slightly.

What is the output of getinput.sh?

http://support.sundtek.com/index.php/topic,54.0.html

gergomez:
It gives /dev/input/event10. I have configure the lirc package first with dpkg-reconfigure and then manually to check everything was right. When I do a /opt/bin/mediaclient -e I get:


device 0: [Sundtek MediaTV Gold]  DVB-C, DVB-T, ANALOG-TV, FM-RADIO, REMOTE-CONTROL, OSS-AUDIO
  [DVB-C]:
     FRONTEND: /dev/dvb/adapter0/frontend0
     DVR: /dev/dvb/adapter0/dvr0
     DMX: /dev/dvb/adapter0/demux0
  [DVB-T]:
     FRONTEND: /dev/dvb/adapter0/frontend0
     DVR: /dev/dvb/adapter0/dvr0
     DMX: /dev/dvb/adapter0/demux0
  [ANALOG-TV]:
     VIDEO0: /dev/video0
     VBI0: /dev/vbi0
  [FM-RADIO]:
     RADIO0: /dev/radio0
  [REMOTECONTROL]:
     INPUT0: /dev/mediainput0
  [OSS]:
     OSS0: /dev/dsp0


should I change the event10 for /dev/mediainput10?

And anyway to check if the remote is working? With some remotes you can see some kind of red light when pressing a button, with others the IR filter is better and you don't see anything. Can I check if the remote is working? Maybe that putting the battery the wrong way would break it?

Regards,

- german

Navigation

[0] Themen-Index

[#] Nächste Seite